Cisco Firepower Management Center 1600 Getting Started Manual page 9

Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Connect Cables Turn On Power Verify Status for Versions 6.5 and Later
This procedure references the rear panel ports of the FMC 1600, 2600, and 4600.
AC power supplies have internal grounding so no additional chassis grounding is required when the supported
AC power cords are used. For more information about supported power cords, see the
Management Center 1600, 2600, and 4600 Hardware Intallation
We recommend that you establish a connection to support alternate access to the FMC for troubleshooting in
case of network outage or other problems that prevent you from accessing the FMC web interface. You can
establish one or more of the three connections listed below; console messages will appear in the output you
select in the FMC web interface under System > Configuration > Console Configuration.
• Connect a keyboard and monitor to the FMC as described in steps 5 and 6. (The FMC sends console
Pre-Configuration Review Network Deployment for Versions 6.5 and Later, on page 6
Pre-Configuration Connect Cables Turn On Power Verify Status for Versions 6.5 and Later, on
page 9
Firepower Use one of the following:
Management Center
•
•
Firepower Review Automatic Initial Configuration for Versions 6.5 and Later, on page
Management Center 18
Firepower Configure FMC Administrative Settings, on page 29
Management Center
Firepower Add Managed Devices to the FMC, on page 38
Management Center
messages to the VGA port by default.)
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Connect Cables Turn On Power Verify Status for Versions 6.5 and Later
Perform Initial Setup at the Web Interface for Versions 6.5 and Later, on
page 12
FMC Initial Setup Using the CLI for Versions 6.5 and Later, on page 15
Cisco Firepower
Guide.
9