Cisco Firepower Management Center 1600 Getting Started Manual page 42

Enable Lights-Out Management
IPMItool (Linux/Mac)
-U username
n/a (prompted on login)
command
For a full list of LOM commands supported by the Firepower system, see the
Configuration
Enable Lights-Out Management
You must be an Admin user to perform this procedure.
Before you begin
• Install an Intelligent Platform Management Interface (IMPI) utility on your local computer. See
• Determine which commands are needed to access an appliance using the IPMI tool. See
• Establish a connection from the CIMC port to a local network reachable from a computer where you will
• Disable Spanning Tree Protocol (STP) on any third-party switching equipment connected to the device's
Procedure
Step 1 In the FMC web interface, choose System > Configuration, then click Console Configuration.
Step 2
For Console, choose Lights Out Management.
Step 3 Choose the address Configuration for the the system (DHCP or Manual).
Step 4
If you chose manual configuration, enter the necessary IPv4 settings:
• Enter the IP Address to be used for LOM.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
42
ipmiutil (Windows)
-U username
-P password
command
Guide.
Utility Installation, on page 41
on page 41 for more information.
run the IPMI utility. See Step 8 of
on page 22 or Connect Cables Turn On Power Verify Status for Versions 6.5 and Later, on page
depending upon your Firepower version.
management interface.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Description
Specifies the username of an authorized LOM
account.
For ipmiutil only, specifies the password for
an authorized LOM account.
The command you want to issue to the
appliance. Note that where you issue the
command depends on the utility:
for more information.
Connect Cables Turn On Power Verify Status for Versions 6.3 - 6.4,
• For IPMItool, enter the command last:
ipmitool -I lanplus -H IP_address -U
username command
• For ipmiutil, enter the command first:
ipmiutil command -V4 -J3 -N
IP_address -U username -P password
Firepower Management Center
LOM Commands,
IPMI
9,