Cisco Firepower Management Center 1600 Getting Started Manual page 28

(Optional) Add Classic Licenses During Initial Setup (Versions 6.3 - 6.4)
Note
Step 12 If you connected directly to the appliance's management interface using an Ethernet cable, once you click
Apply you will be disconnected from the FMC because its IP address has changed. Disconnect the computer
and connect the FMC's management interface to the management network. To complete the remaining
procedures in the guide use a browser on a computer on the management network to access the FMC GUI at
the IP address or host name that you just configured.
Step 13 Verify that the initial setup was successful by monitoring the Tasks tab in the Message Center.
What to do next
• Perform the activities described in
• Optionally, configure the FMC for Serial or Lights-Out Management (LOM) access; see
(Optional) Add Classic Licenses During Initial Setup (Versions 6.3 - 6.4)
You use the FMC to manage classic licenses for 7000 and 8000 Series, ASA with FirePOWER Services, and
NGIPSv.
Note You must enable Classic Licenses on your managed devices before you can use licensed features. You can
enable a license during the initial setup of the FMC (as described in the procedure below), when you add a
device to the FMC, or by editing the device's general properties after you add the device.
Before you begin
Before you add a classic license to the FMC, make sure you have the Product Authorization Key (PAK)
provided by Cisco when you purchased the license. If you have a legacy, pre-Cisco license, contact Cisco
TAC.
Procedure
Step 1 Obtain the License Key for your chassis from the License Settings section on the Initial Setup page.
The License Key is clearly labeled (for example, 66:18:E7:6E:D9:93:35).
Step 2 To obtain your license, navigate to
Key (for example, 66:18:E7:6E:D9:93:35) and the PAK.
Note
Step 3 Follow the on-screen instructions to generate a license or licenses, which will be emailed to you.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
28
If your network environment uses NAT, the browser may time out attempting to reach the FMC
using the address configured on the intial setup page. In this case, enter the correct address in the
browser address window and try again.
FMC Access, on page 39.
If you ordered additional licenses, you can enter the PAKs for those licenses at the same time,
separating them with commas.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Configure FMC Administrative Settings, on page
https://www.cisco.com/go/license/
29.
Set Up Alternate
where you are prompted for the License