Table of Contents
Advertisement
5.4.9
PRESETS
The Presets display allows the saving and recalling of configurations to and from memory. The display is shown below.
The PRESET menu is used to define a Preset file number nn, in the range from 1 to 30, to which the current module
program is to be stored or from which the module is to be loaded. All setup registers and memory locations required to
operate the program are stored or retrieved.
Table 10: Selectable Definitions of the actions field on the Presets display
Field
Definition
Preset
File Number of the current program to be Saved or the number assigned to a previously Saved
program to be Loaded, 1 to 30
Status
Status indication for the saving or loading process. The message Ready indicates that the process
is idle and awaiting an operator action. Saving indicates that the current program is being saved
as a result of the operator pressing F1. After requesting the module to be loaded by depressing F2,
the status indication Loading is displayed. If the requested Preset file number is invalid, the status
No Preset is displayed.
Function Keys
F1
Go directly to Measurements display
F2
Save the Current settings to the Preset file number specified
F3
Load the current settings to the Preset file number specified
F4
The Load defaults command does not clear out any of the Preset fields, but preps the unit to come
up in a factory default configuration on the next power cycle. The presets will still be saved and
will not be cleared out.
NOTE: When saving to a Preset, data saved from the Edit PCM menu only include the data words that are included
within the active words (as defined by Words/Frame field). Refer to PCM Setup Figure 14 for information
on configuring the frame size.
rd
210 South 3
Street, North Wales, PA 19454
Tel: 215.699.2060 Fax: 215.699.2061
Figure 17: PRESET Control Screen
16
09.21.2017
F1
F2
F3
F4
F5
A
L
, I
.
POGEE
ABS
NC
Advertisement
Table of Contents
