Cisco 7304 Installation And Configuration Manual page 17

Chapter 1 Overview
Figure 1-3
SMB connector
Electromagnetic compliance (EMC) was verified with the 10-foot (3.048 meters) shielded cables that are
Note
orderable through Cisco. We recommend that you use only the 10-foot (3.048 meters) shielded SMB
cables; otherwise, EMC is not guaranteed.
If you use cables other than those ordered from Cisco, it is your responsibility to ensure that you have a
compliant system that meets local EMC requirements. To order additional cables, use the product
numbers: 2CBLE-SMB-BNC-M (male) and 2CBLE-SMB-BNC-F (female).
Observe the receive (RX) and transmit (TX) cabling relationship shown in
Note
Figure 1-4
To RX
To TX
After you connect the cables to a configured port on the line card, it takes up to 35 seconds to initialize
Note
the line card and light the green LNK LED.
OL-5061-01
SMB Cables (SMB Terminates into BNC)
Connecting the SMB Cables
7 3 0 0 -6 E
3
T X
O IR R X
0
S T A T U S
6 -P O R T L N K
E 3 D S U
Cisco 7304 6-Port Clear Channel E3 Line Card Installation and Configuration
T X
R X
1
T X
R X
2
L N K T X
R X
3
L N K
L N K
SMB Cables
Male BNC Female BNC
connector connector
Figure 1-4.
T X
R X
4
T X
R X
5
L N K
L N K
1-5