Honeywell FF-SB12 Series Installation Manual page 58

Using Soap and Water
POWER APPLIED TO MACHINE CONTROL SYSTEM
Turn off and disconnect power from FF-SB Series light curtain and machine.
Failure to comply with these instructions could result in death or serious injury.
FF-SB SERIES LIGHT CURTAIN FRONT PLATE AND FINISH DAMAGE
Do NOT use solvents to clean emitter or receiver to prevent damage to clear plastic front plate and paint
finish.
Failure to comply with these instructions may result in product damage.
1. Turn off and disconnect power to the light curtain and machine.
2. Dampen a soft, clean, non-abrasive cloth in the solution of mild soap and water. Squeeze excess
solution from the cloth.
3. Wipe the soiled areas gently with the damp cloth. Do not rub hard to prevent scratching the clear plastic
front plate or paint finish.
4. Rinse the cloth in clean water and gently wipe off any excess soap.
5. Dry the emitter and receiver with a soft, dry, non-abrasive cloth. Ensure there is no moisture left on the
emitter and receiver units before power is applied.
6. Connect power to the machine and light curtain.
7. Perform the operational test to ensure proper functional readiness.
Cleaning the Mirrors
FF-SBMIR SERIES MIRROR DAMAGE
Use soft, clean, non-abrasive cloth to clean dust or dirt from mirror to prevent scratching surface.
Failure to comply with these instructions may result in product damage.
1. Dampen a soft, clean, non-abrasive cloth with 90 % alcohol or white spirit.
2. Wipe the face of the mirror gently with the damp cloth. Do not rub hard to prevent scratching the finish.
3. Dry the mirror with a soft, dry, non-abrasive cloth. Ensure there is no moisture or lint left on the mirrors.
4. Perform the operational test to ensure proper functional readiness.
107062-12 EN FR26 GLO 501 Printed in France
65