Honeywell FF-SB12 Series Installation Manual page 8

IMPROPER SYSTEM PERFORMANCE
• Consult local safety agency before designing a machine control system.
• Comply with local safety requirements when designing machine control link, interface and all control
elements that affect safety.
• Install two independent safety relay contacts into machine control stop circuit controlled by FF-SB Series
light curtain.
• Ensure two independent stop circuit relays have mechanically linked contacts that prevent contact
overlapping in the event of a welded contact.
Failure to comply with these instructions could result in death or serious injury.
FF-SB12, FF-SB14 and FF-SB15 Series light curtains are designed so a malfunction or an interruption of the
sensing field will cause the light curtain to generate a stop signal within a maximum of 30 milliseconds. This
stop signal will be generated automatically if a malfunction occurs in the light curtain. All other machine
control components that affect safety should also be designed to the same high level of operation.
IMPROPER MACHINE REACTION
• Ensure the machine control is capable of stopping the machine at any point in the cycle.
• Ensure that a loss of power does NOT impair stopping action of machine.
Failure to comply with these instructions could result in death or serious injury.
Figure 1-1 Point-of-operation Guarding (use FF-SB12 or FF-SB14 only)
Operator enters danger zone
under the light curtain
Point-of-operation is defined as that area where a machine performs work (such as cutting, shaping, boring,
or forming) on a material.
FULL REVOLUTION MECHANICAL POWER PRESSES CANNOT BE STOPPED IN MID-STROKE (OSHA
29CFR 1910.217). Do NOT use FF-SB Series light curtains on full revolution mechanical power presses.
Failure to comply with these instructions will result in death or serious injury.
14
Operator enters danger zone
above the light curtain
107062-12 EN FR26 GLO 501 Printed in France