Table of Contents
Advertisement
Stopping and Starting the Pump
Starting the Sparus
™
Technology
1. Be sure the pump is powered on and the green
power LED is on.
2. Select one of the speed buttons, then press the
Start/Stop button (LED on) to start the pump. The
pump will go into priming mode if priming feature
is enabled.
Stopping the Pump
1. Press Start/Stop to stop the pump.
When servicing equipment, disconnect the communi-
cation cable, and switch OFF circuit breaker to remove
power from the pump.
Note: The pump can automatically restart if the
communication cable is connected.
To Adjust and Save a Pump Speed
1.
While the pump is running, press the Up or Down
arrow to adjust to desired speed setting.
2.
Press and hold down a Speed button (1-4) for three
(3) seconds to save speed to the button or press
Enter to save the speed.
Operating the Pump at Preset Speeds
The pump is programmed with four default speeds of 40,
50, 60 and 70 GPM. Speed buttons 1-4 are for each of
the preset speeds.
1. Be sure the pump is powered on and the green
power LED is on.
2. Press the Speed button (1-4) corresponding to the
desired preset speed and release quickly. The LED
above the button will turn on.
3. Press Start/Stop. The pump will quickly change to
the selected preset speed.
LED lit
LED lit
Speed
Speed
1
2
Pump with Constant Flow
Speed
Speed
3
4
SPARUS
Pump Operating Modes
The pump can be programmed in three different modes:
Manual, Schedule, and Egg Timer.
Speeds 1-4 can be programmed in all three modes.
Speeds 5-8 can only be programmed in Schedule mode
since there are no buttons on the control panel for Speeds
5-8. The default setting for Speeds 5-8 is "Disabled".
Speed 1 (1-4)
Speeds 1-4 Menu Guide
Speed 5 (5-8)
Speeds 5-8 Menu Guide
1. Manual: Assigns a speed to one of the four Speed
buttons on the control panel. This mode can only be
used for speeds 1-4.
To operate in Manual mode, press one of the four
speed buttons and then press Start/Stop. The
pump will run the assigned speed for that speed
button.
2. Egg Timer: Speeds 1-4 can be programmed to run
for a duration of time once a speed button is pressed.
To operate in Egg Timer mode, press a speed button
and then press Start/Stop. The pump will run that
speed for the set amount of time and then turn off.
3. Schedule: Program speeds 1-8 start and stop at
a specific time during a 24 hour period. Speeds
programmed in Schedule mode will override any
manually selected speed (speeds set by manually
pressing any of the speed buttons on the control
panel).
Control Panel Language
The default language is English.
1. Check that the green power LED is on.
2. Press Menu and press Select to select "Settings".
3. Use the Up or Down arrows and scroll to "Language".
4. Press Select. Press Select again to highlight current
language in use.
5. Press Enter to select the control panel language. To
cancel any changes, press Escape to exit without
saving.
6. Press Escape to exit.
Pump with Constant Flow Technology Installation and User's Guide
™
Manual
Set Speed
Schedule
Set Speed
Set Start Time
Set Stop Time
Egg Timer
Set Speed
Time
Disabled
Default: Disabled
Schedule
Set Speed
Set Start Time
Set Stop Time
7
Advertisement
Table of Contents
