Set Programs 1-8 In Schedule Mode - Pentair INTELLIFLO VSF Installation And User Manual

MENU
Pump Menu: Programs 1-8
PROGRAM 1-8

Set Programs 1-8 in Schedule Mode

In Schedule mode, Programs 1-8 can be programmed
to run a certain speed or flow at a certain time of day. To
run a scheduled speed or flow, press Start/Stop. The
screen will display "Running Schedules" when it is ready
to run a scheduled speed/flow. If Start/Stop is pressed
while a scheduled speed/flow is running, the pump will
stop running the scheduled speed/flow. The pump will not
continue to run the scheduled speed/flow until the Start/
Stop button is pressed again.
1. Press Menu.
2. Use Up or Down arrows to scroll to "Program 1-8",
then press Select.
3. Use Up or Down arrows and press Select for the
speed you wish to set and schedule.
4. "Operation Mode" will display. Press Select and
use the Up or Down arrow to scroll to "Schedule".
Press Save.
5. Use the Up or Down arrow to scroll to "Set Type".
Press Select and use the Up or Down arrow to
choose between "Speed" or "Flow". Press Save.
6. Use the Up or Down arrow to scroll to "Set Speed/
Flow". Press Select and use the Up or Down
arrow to adjust the speed or flow settings.
7. Press Save to save the new speed or flow setting.
8. Press the Down arrow again, "Start Time" will
display. Press Select - the cursor will highlight the
minute column.
9. Use the Up or Down arrow to change the time
and the Left or Right arrow to move cursor from
minutes to hours.
10. Press Save to save the new start time setting.
11. Press Down arrow - "Stop Time" will display. Press
Select. Repeat Steps 8-9 to set stop time.
12. Press Save to save the new stop time setting.
13. Press Start/Stop.
The IntelliFlo VSF Variable Speed and Flow Pump will
®
prime and begin to run the programmed schedule at the
specified start time.
When running in Schedule or Egg Timer mode, the
countdown time (T 00:01) showing the hours and
minutes remaining is displayed.
Programming Schedule for Constant Run
Two programs cannot be programmed with the same
start and stop times. To run a program without stopping,
set the Start time one minute after the stop time.
Example: A single program will run non-stop if
programmed with a Start Time of 8:00 AM and a Stop
time of 7:59 AM.
Schedule
Operation Mode
Note: The pump will not run the scheduled speeds or flows
until the Start/Stop button is pressed (LED on) to place the
pump in Schedule mode.
Scheduled Program Priority
When operating the pump in Schedule mode it is important
to keep each program within its own individual run time. If
program run times overlap the pump will prioritize programs
as explained below:
Schedule priorities are in descending order as follows:
Highest Flow » Lowest Flow » Highest Speed » Lowest
Speed
When two speed OR two flow program schedules
•
overlap, the pump will run the higher RPM Speed or
GPM Flow regardless of program in use.
• When both a speed AND flow program schedule
overlap the pump will run the flow program first.
• A manual or egg timer command takes precedent
over a running schedule. The manual or egg timer
command will operate until completed, unless the
next schedule program takes place or another
command is given.
INTELLIFLO VSF Variable Speed and Flow Pump Installation and User's Guide
®
12:15p
750 RPM
T 1:05 150 Watts
Running Speed 1
15
12:15p