Yetter 2967-003A Operator's Manual page 10

Lubrication Symbols
Lubricate with polyurea grease at hourly interval indicated on symbol.
Lubrication Intervals
IMPORTANT: The recommended service intervals are based on normal conditions;
severe or unusual conditions may require more frequent lubrication.
Perform each lubrication and service procedure at the beginning and end of each
season.
Clean grease fittings before using grease gun, to avoid injecting dirt and grit into the
bearing. Replace any lost or broken fittings immediately. If a fitting fails to take grease,
remove and clean thoroughly, replace fitting if necessary. Also check for failure of
adjoining parts.
Storing the Equipment
Store the machine in an area away from human activity
Store machine in RAISED position.
Install service locks on all wheel cylinders.
At the end of the season, the machine should be thoroughly inspected and prepared for
storage. Repair or replace any worn or damaged components to prevent down time at the
start of the next season. Store machine under cover with all parts in operating condition.
 Clean machine thoroughly to remove all dirt, debris and crop residue, which would
hold moisture and cause rusting.
 Inspect machine for worn or broken parts. See your Yetter Farm Equipment dealer
during the off-season so that parts or service can be acquired when machine is not
needed in the field.
 Lubricate bearings as outlined in the Lubrication section
 Paint all parts which are chipped or worn and require repainting.
 Store machine in a clean, dry place with the planting unit out of the sun.
 If the machine cannot be stored inside, cover with a waterproof tarpaulin and tie
securely in place.
 Do not allow children to play on or around the machine

10
MAINTENANCE