Table of Contents
Advertisement
3
Safety
3.1
Appropriate use
The VoE IOBox provides an interface between industrial process technology and the
personal computer (PC).
It is intended for use on a PC, which is equipped with an Ethernet interface. The PC is
subject to EC Directive 89/336/EEC and must meet the EMC protection requirements.
Products that meet these requirements bear the CE mark.
The data between the VoE IOBox and the PC is exchanged via a shielded CAT6 cable with
an X-Cross connector on the side of the module. The cable is connected to the X1 socket.
The module has 6 inputs and 4 outputs for processing digital 24 V signals.
For operation of the inputs and outputs, an external 24 V supply voltage is required. The
terminals are divided into two groups with the GND potential. The inputs E1.0-E1.7 and the
outputs A1.0-A1.7 have a common GND potential as well as the inputs E2.0-E2.7 and the
outputs A2.0-A2.7.
The use of the VoE IOBox in combination with external clamping or relay boards requires
professional installation in a closed control cabinet.
Therefore check the shielding capacity of the PC housing and cable shield before using the
equipment.
Any other use or use beyond the scope of this document is deemed contrary to the
designated use. The manufacturer shall not be liable for any resulting damages.
The intended use requires compliance with all instructions in the technical manual.
Limits of use
When using the VoE IOBox, in a plant, the interference resistance and emissions of the plant
can also change. Increased emission or decreased interference resistance could means that
the conformity of the system is no longer ensured.
The VoE IOBox must remain in its original packaging until use.
Do not remove the identification numbers (serial number) of the VoE IOBox. To do so
will result in loss of the warranty.
Technisches Handbuch
Version 5.2
Safety
5
Advertisement
Table of Contents
