ADJ DOTZ MATRIX User Instructions page 15

SYSTEM MENU
DMX Mode - Set the DMX Address and DMX Channel Mode -
1. Press the MENU button until "DMX Mode" and underneath "ADDR: XXX" and "CH:XX" is displayed,
press ENTER.
2. "XXX" will now begin to flash, use the UP and DOWN buttons to find your desired DMX address,
then press ENTER.
3. "XX" will now begin to flash, use the UP and DOWN buttons to find your desired DMX Channel
mode, then press ENTER.
Secondary Mode- This will let you set your unit as a secondary in a Primary/Secondary
configuration.
1. Press the MENU button until "Secondary Mode" is displayed. Your unit will now follow the Primary.
Sound Mode - In this mode the unit will run in sound active mode.
1. Press the MENU button until "Sound Mode" is displayed.
2. Press ENTER to adjust your sound sensitivity. When you press ENTER the number next to "Sens"
will begin to flash, use the UP and DOWN buttons to adjust the sound sensitivity. Once you found
your desired sensitivity press ENTER to confirm.
3. When you press ENTER the number next to "FQN" will begin to flash, use the UP and DOWN
buttons to adjust the amount of times you would like the program to cycle before changing to the
next program. Press ENTER to confirm.
Auto Run-
1. Press the MENU button until "Auto Run" is displayed, and "FQN:XX" will be displayed underneath.
"XX" representing the number displayed.
2. Press ENTER and the number will begin to flash, use the UP and DOWN buttons to adjust
the amount of times you would like the program to cycle before changing to the next program. Press
ENTER to confirm.
Built-In Programs - See the chart on page 14 to find your desired program.
1. Press the MENU button until one of the Programs on page 7 is displayed. The displayed program
depends on the last program you had set the unit to.
2. Press ENTER to move through the various adjustments of each program, and use the UP and
DOWN button to make adjustments.
Pixel Flip - In this mode you adjust the unit so that the LEDs in DMX mode will illuminate at your
desired starting point.
Example: If the unit is set to Flip 1, in 48 Channel mode, the first pixel will light up starting on the
top right. If set to Flip 2, in 48 Channel mode, the first pixel will light up starting on the bottom
right.
1. Press the MENU button until "Pixel Flip" is displayed, press ENTER.
2. Either "Standard" or "Flip X", "X" representing a number between 1-4. Use the UP or DOWN buttons
to find your desired setting.
15