Table of Contents
Advertisement
2.3 REMAINING SYSTEM INSTALLATION
When you have configured headers J1 through J4, you are through with P3EM configuration:
• To install the P3EM in an MMDS05 station module, remove the panel from the station-
module top. Fit together EM connectors P2 and P3 (on the bottom of the board) and
control-board connectors P11 and P12. Snap the corners of the EM onto the plastic
standoffs. Connect the target cable, if appropriate. Replace the panel.
• If your P3EM already is installed in the station module, reconnect the target cable (if
necessary). Replace the panel.
At this point, you are ready to make remaining cable connections, as necessary, and restore
power. For instructions, consult the MMDS05 operations manual (MMDS05OM/D).
M68HC05P3EM/D
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
3-13
MOTOROLA
Advertisement
Table of Contents
