Mpud Indicators - Huawei Eudemon8000E Series Manual

HUAWEI Eudemon8000E Firewall
Hardware Description
Indicator
FAULT
A.3.3 MPUD Indicators
Table A-12
Table A-12 Buttons and indicators on the MPUD Panel
Indicator/
Button
OFL button
OFL indicator
(red)
RUN indicator
(green)
ALM indicator
(red)
ACT active/
standby indicator
(green)
Reset button
CF ACT indicator
(green)
LINK indicator
(green) (on the
Ethernet
interface)
Issue 01 (2012-11-07)
Color
Red
lists the status and descriptions of MPUD indicators.
Description
To remove a board, you must hold the button for six seconds until the
OFL indicator turns on.
NOTE
This button takes effect only on the slave MPUD.
If the indicator is on, it indicates that you can remove the board.
If the indicator blinks once every two seconds (0.5 Hz), it indicates that
the system is in the normal state. If the indicator blinks twice each second
(2 Hz), it indicates that the system is in the alarm state.
If the indicator is steady on, it indicates that the system is in the alarm
state.
If the indicator is steady off, it indicates that the system is in the normal
state.
If the indicator is on, it indicates that the MPUD is in the active state.
If the indicator is off, it indicates that the MPUD is in the standby state.
The button is used for resetting the MPUD. Press the Reset button, and
you can reset the MPUD.
If the indicator is on, it indicates that the CF is in position.
If the indicator is blinking, it indicates that data is being read or written.
If the indicator is off, it indicates that the CF is not in position or can be
removed.
If the indicator is steady on, it indicates that the link is normal.
If the indicator is off, it indicates that the link is Down.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
It indicates a fault. If it is steady on, it indicates that
an unrecoverable fault occurs on the power module.
For example, fans are faulty, no current is output, or
output current is short circuited.
A List of Indicators
147