Advertisement
important that the washers touch the magnets in the correct flat angle, otherwise the magnetic
force will not be fully utilized. The correct procedure is to glue the washers at the exactly right
position to the door first, then click the magnets on to the washers, close the gear doors and so
sink the magnets into the recesses/holes prepared for them and glue them with Hysol in place.
Make sure no Hysol contacts the washers on the doors. That way you make sure that the contact
between magnet and washer is perfect. Once the glue has set, open the gear door and fill and re-
glue where needed, both the washers and the magnets to hold them in place safely. You will love
that clicking sound when the gear doors safely lock in place....)
Now repeat the gear installation on the opposite wing, and that should complete all work on the
wing except routing all wires and placing the connectors, which can be done when all the other
parts are finished, too.
Advertisement
