Table of Contents
Advertisement
Receiver and Remote Control Programming
NOTICE: To comply with FCC rules, adjustment or modification of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the transmitter battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Your garage door opener receiver and remote control
transmitter have been set at the factory to a matching
code. The door will open when you press the remote
control push button.
Your "Smart" garage door opener will operate with:
•
up to four "Smart" remote control transmitters
(with green indicator lights),
• a Keyless Entry System, and
• code switch remote controls with red indicator
lights.
Below are instructions below for programming your
opener to match any additional remotes you may
purchase. See available accessories on page 34.
To Add A Remote
hold the remote push button. See
1. Press and
Figure 1.
2. Then press and release the green "Smart" button
on the back panel of the opener in Figure 2. The
indicator light on the panel will flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed.
If you release the remote control push button
before the indicator light flashes, the opener will
not accept the code.
To Erase All Remote Control Codes
• Press and hold the green "Smart" button on the
opener panel until the indicator light turns off (about
6 seconds). All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 – 3 for each remote
control in use.
Code programming instructions are also located
on the opener panel.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door control or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Figure 1
Single-Function Remote Control
Green Battery
Indicator Light
Figure 2
(With "Smart" Button)
"Smart"
Button
29
WARNING
Push Button
Garage Door Opener
1
2
3
9
9
1
7
7
3
5
5
KG
KG
Indicator
Light
END PANEL
1
3
Advertisement
Table of Contents
