Install The Receiver; Set Security Mode; Programming The Remote To The Receiver; To Erase All Remote Control Codes - Chamberlain MEGA SWING Owner's Service Manual

WARNING
WARNING WARNING
To prevent possible SERIOUS INJURY or DEATH from a
moving gate or garage door:
• ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door
travel.
• ALWAYS keep gate or garage door in sight until completely closed
NEVER permit anyone to cross path of moving gate or door.
AVERTISSEMENT

SET SECURITY MODE

The Universal Receiver can be used with up to 15 rolling code
remotes or passwords in HIGH security mode. Alternately, it can
AVERTISSEMENT
be used with up to 31 of any type remote in NORMAL security
mode, including any combination of rolling code, billion code, or
dip switch remotes.
The jumper must be set at the HIGH position for the receiver to
operate in HIGH security mode. It must be set at NORMAL
position to operate at the NORMAL mode (Figure 1).
When changing from NORMAL to HIGH security mode, any
previous remote codes must be erased. Repeat Steps 2 and 3 in
the Programming Section below to reprogram the receiver for
each remote control in use.
The receiver is factory set at HIGH.

PROGRAMMING THE REMOTE TO THE RECEIVER

1. Pry open the front panel of receiver case with a coin or a
screwdriver. Re-connect power to opener (Figure 2).
2. Press and release the "learn" button on the receiver. The
learn indicator light will glow steadily for 30 seconds.
3. Within 30 seconds, press and hold the button on the
ADVERTENCIA
hand-held remote that you wish to operate your gate.
The opener will now operate when the push button on either the
receiver or the remote control is pressed.
ADVERTENCIA
Repeat Steps 2 and 3 for each remote control that will be used to
operate the gate.

TO ERASE ALL REMOTE CONTROL CODES

Press and hold the "learn" button on the receiver panel until the
indicator light turns off (about 6 seconds). All remote codes are
now erased. Then follow the steps above to reprogram each
remote control.
I N S T A L L T H E R E C E I V E R
FIGURE 1
OPENING RECEIVER
FIGURE 2
15
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Jumper
Security Mode
Terminals
HIGH
SECURITY MODE
OPEN RECEIVER
Connect
Antenna
24V
Jumper
Security Mode
Terminals
NORMAL
SECURITY MODE
Indicator Light
Learn Button
Output Duration
C
P2
M Terminals
Security Mode
Power Supply
12V
Jumper
(Not Provided)