Bosch KTS 515 Product Description page 21

4. Initial start-up
!
It is not possible to operate another piece of bluetooth
hardware installed or plugged into the PC/laptop, as
the data communication between the KTS module and
the control unit would be disrupted as a result.
1. Before the initial startup of the bluetooth USB adapt-
er, the bluetooth hardware integrated in the PC/
laptop (e.g. Widcomm Stack/Toshiba Stack) must be
deactivated (see PC/laptop operating instructions).
i
The DCU 130 with internal Bluetooth hardware does
not require the use of the supplied Bluetooth USB
adapter and the installation of the Bluetooth driver.
2. In addition, the appropriate bluetooth driver must be
uninstalled (remove bluetooth driver under "Start >>
Settings >> Control Panel >> Software").
!
Do not plug in the Bluetooth USB adapter until
requested to do so during installation of the Blue-
tooth driver on your PC or laptop (Message: Con-
nect Bluetooth device). If the Bluetooth USB adapter
is plugged in too soon, the Windows hardware as-
sistant is opened. The Windows hardware assistant
must be terminated and the
Bluetooth USB adapter removed.
4.1 Installing SystemSoft BEA-AU-OBD
i
On installing the BEA PC software, the "On-Board
Diagnosis" PC software is also installed on the PC/
Laptop.
1. Close all open applications.
2. Insert the "SystemSoft BEA-AU-OBD" CD in the DVD
drive.
3. Start "Windows Explorer".
4. Start 'D:\RBSETUP.EXE' (D = DVD drive letter).
 BEA set-up is started.
5. Confirm with <Continue>.
6. Heed and follow the instructions on the screen.
i
The Bluetooth driver is installed at the end of instal-
lation. During installation, the Bluetooth USB adapt-
er must be plugged in when prompted to do so.
7. Re-start the PC/Laptop to successfully conclude
installation.
"
This completes installation of SystemSoft BEA-AU-
OBD and the "On-Board Diagnosis" PC software.
Robert Bosch GmbH
Initial start-up | KTS 515 | 21
4.2 Connection KTS 515
1. Connect the KTS 515 to the power supply unit in-
cluded in the scope of delivery.
2. Connect the KTS 515 to a PC/Laptop via the USB
connecting cable.
i
The message "New hardware found" appears on the
screen for a few seconds the first time the KTS 515
is connected by way of the USB connecting cable.
This indicates recognition of the USB connection to
the KTS 515.
4.3 Module configuration (DDC)
i
The DDC (Diagnostic Device Configuration) software
is used for configuration, activation and the testing
of KTS modules.
1. Start on-board diagnosis ("Start >> Programs >>
Bosch >> Diagnostics >> Bosch on-board diagnosis").
2. Open "Settings" with <F7>.
i
Pressing <F1> opens the Online Help.
3. Call up "DDC" with <F4> and start with <F12>.
en
| |
1 689 989 036 2015-07-28