Back Angle Adjustment; Quick Back Tilting Adjustment; Seat Belt Height Adjustment; Seats Maintenance - Ford F-MAX User Manual

OPERATION
Seats and Beds

Back angle adjustment

To adjust the back inclination angle while
sitting on the seat, desired position is
obtained by pulling the lever on the left of
the seat upwards and moving your back
4
forward or backward.

Quick back tilting adjustment

Move the lever on the inner upper area of
the seat clockwise in order to adjust the
quick back tilting function.

Seat belt height adjustment

Height adjustment of the seat belt may
be adjusted at 4 levels by moving the belt
up or down by pressing and holding the
button.
Maintenance
Dirt may hinder the operation of the driver
seat. Keep your seat clean to prevent this!
CAUTION
There is a risk of injury if the backrest
bounces forward!
WARNING
Discharge the air by pressing the rapid
lowering button when you are getting
off the vehicle. This would increase the
service life of the seat mechanism.
CAUTION
If the seat is used without air charge, this
would damage the internal mechanism
of the seat
and render the seat out of warranty
cover.
Adjustment of the seat while driving may
cause unwanted steering movements
and injuries.
-Adjust the seat when the vehicle is
stationary only.
-Adjust the seat when you are sitting
on the seat when there is no one in the
setting range of the seat.
General safety notes
Do not keep cutting, piercing tools or items
on the upper and lower beds, on the seat
and in the side pocket of the seat so that
the items do not cause damage inside the
cab when the cab is tilted to the front.
- 70 -
Do not use the seat heating function to dry
the seat fabric it it is wet.
Do not try to push the seat bellow with
your hand as it may cause a risk of injury.
General cleaning notes
Dirt may hinder the operation of the driver
seat. Therefore, apply the required care for
cleaning of the seat and keep your seat
clean.
Do not try to push the seat bellow with
your hand as it may cause a risk of injury.
Do not try to remove seat fabric while
cleaning the seat. Bedding may be
removed for cleaning of the bed. The
cleaning instructions on the mattress
cover shall be followed.
When cleaning the fabric or the plastics of
the seat, the bed and the seat belts, apply
the cleaning material to a small area fi rst
to test the suitability of the material. Do
not use fl ammable or abrasive cleaning
materials.
Do not use high pressure cleaners to clean
your seat, bed and the seat belts.