Maintenance - Chicco New Zenith 0+1 Instructions Manual

is the safest; in this case, it is recommended
to fi t the child car seat into the central rear
seat of the car.
If the child car seat is fi tted in the front seat
of the car, in order to ensure maximum safety,
it is recommended to push the seat back as
much as possible, bearing in mind the comfort
of the passenger sitting in the seat directly
behind it.
If the car is equipped with a safety belt height
adjuster, fi x it in the lowest position, then
check that the car seat safety belt adjuster is
either in a backward position with respect to
the backrest of the car seat (or at least aligned
to it)(see diag. 4).
If you wish to fi t the child car seat in any seat
protected by airbag, always refer to the vehi-
cle instructions manual.

MAINTENANCE

The cleaning and maintenance operations
must only be carried out by an adult.
How to Clean the Fabric cover
The child car seat's fabric cover can be re-
moved and cleaned. Please refer to the care
label for instructions on cleaning the seat
fabric.
Clean the fabric cover only with a sponge,
neutral detergent and water.
Never use abrasive detergents or solvents.
Do not spin the fabric cover, let it dry without
wringing.
How to Clean the Plastic Parts
Clean the plastic parts with a soft, damp cloth
or a neutral detergent.
Never use abrasive detergents or solvents.
The movable parts of the child car seat must
not be lubricated.
Checking the Condition of the Compo-
nents
It is recommended to check regularly the con-
dition of the following components to ensure
that they are not worn out:
• Fabric cover: Check that the padding does
not come out from the seams. Check the
condition of the seams: they must always
be intact and undamaged.
• Plastic parts: Check that the plastic parts
are not worn out, damaged or faded.
Storing the Product
When it is not fi tted into the car, it is rec-
ommended to store the child car seat in a
dry place, away from sources of heat and to
protect it from dust, humidity and direct sun-
light.
INSTRUCTIONS
Components
A. Fabric cover
B. Headhugger
C. Triple padding (shoulder straps and central
bumper bar)
D. Child car seat safety harness holes
E. Button for adjusting the length of the safe-
ty harness
F. Strap for adjusting the length of the safety
harness
G. Adjustment lever for reclining the child car
seat
H. Side guides for lap belt section of car safety
belt, for Group 0+
I. Carry handle
J. Guide for diagonal section of car safety
belt, for Group 0+
K. Side clamps for diagonal section of car
safety belt used for Group 1.
L. Side guides for lap section of car seat belt
used for Group 1
M. Rear side joint
N. Anchor-shaped buckle
O. Safety belts
P. Safety belt straps
Q. Safety belt buckle
R. Button for opening the buckle
Index
• How to adjust the safety harness of the
child car seat
• How to fi t the child car seat into the car for
Group 0+ (from 0 up to 13 Kg)
• How to fi t the child car seat into the car for
Group 1 (from 9 up to 18 Kg)
• How to place baby into the child car seat
• How to recline the child car seat
• How to remove the fabric cover
How to Adjust the Safety Harness of the
Child Car Seat
WARNING! The safety harness must always be
adjusted to suit baby's growth.
30