PMS 2747 and PMS 186
INSTRUCTIONS:
IMPORTANT: Please also refer to the instructions that came with your product.
Rotate the Carry Handle up into the carry position. To remove the Canopy, unhook the Elastic Straps on both sides,
1
below the Carry Handle hub. Undo both Toggles on the back of the Child Restraint. On one side of the Canopy, press the
button on the Canopy Mount and pull out the bow. Repeat for the other side of the Canopy and remove. Then rotate the
Carry Handle back into stationary position. Refer to User Guide if needed.
Press the Harness Adjuster Button and loosen the
2
Harness Straps. Undo the buckle and chest clips.
Remove the optional Head Rest Insert and Newborn
4
Positioner. Refer to User Guide if needed.
WARNING: Avoid serious injury or death to your child. Never
use your KeyFit 35 Child Restraint without the softgoods in place.
You must read and understand the Softgood Removal instructions
and the instructions in the User Guide. If you do not understand
these instructions, DO NOT attempt to remove the softgoods,
STOP and call Chicco at 1-877-424-4226.
KeyFit 35 Softgood Removal
3
through the slot on the BACK of the Harness Buckle. Then
pull Tab out of the FRONT and remove Crotch Strap Pad.
IMPORTANT! If Crotch Strap Pad prevents harness from properly
fitting small Infant, it should be removed.
5
sections located on the outside seam of the Shoulder Pad.
1
Remove the Crotch Strap Pad by pushing the fabric Tab
Remove both Shoulder Pads. Undo the hook and loop
SS0030E_01
Need help?
Do you have a question about the KeyFit 35 and is the answer not in the manual?
Questions and answers
how do I raise the harness
To raise the harness on the Chicco KeyFit 35:
1. Remove your child from the carrier.
2. Turn the carrier over.
3. Locate the height adjuster.
4. Pull the harness straps through the openings.
5. Re-thread the harness straps into the openings at the new, higher position on the height adjuster plate.
6. Attach both harness straps securely to the splitter plate, ensuring they are not twisted and are above the height adjuster plate.
This answer is automatically generated