Sun Canopy; Maintenance - Chicco Seat2Fit i-Size Instruction Manual

justment button (E) while taking hold of the
two harnesses below the shoulder straps and
pulling toward yourself (Fig. 18). Next, pull up
on the adjustment ring (G) located above the
headrest (Fig. 26) and move the headrest to the
desired position; now release the ring and ease
the headrest until a click is heard, indicating that
it is locked correctly into position.
WARNING! Do not over-tighten the harnesses
around the child: If you can insert one finger be-
tween the harness and your child's shoulders, it
means that it is tightened correctly.
9. ADJUSTING THE INCLINATION OF THE
CHILD CAR SEAT
The child car seat can be reclined to 4 posi-
tions. To adjust the inclination of the child car
seat, pull the reclining lever (J) (Fig. 27). When
the child car seat is fitted rear-facing, it must be
adjusted to the maximum recline position (4).
WARNING! When fitted rear-facing, the other
positions cannot be used.
When fitted front-facing, the seat can be ad-
justed to the 4 positions provided.
10. ROTATION
The car seat is equipped with a system that
allows for 360° of rotation by activating the
lever (K).
The intermediate position at 90° can be used
to simplify the task of seating the child in the
car seat.
WARNING! Do not use the intermediate 90°
position when the car is moving.
11. ADJUSTING THE CAR SEAT BUCKLE
The child car seat buckle can be adjusted to
two different positions: A and B.
At the moment of purchase the buckle is in
position A (Fig. 28)
Position A: Can always be used;
Position B: Can be used with older children
who are at least 60 cm tall;
To switch from position A to position B one
must:
Remove the padded crotch strap (I), lift the
fabric off the seat and pass the buckle strap
through the slot (Fig. 29) from position A to
position B (Fig. 30). After this check that the
belt has not rolled up. Pull the buckle several
times to check it is inserted correctly. After ad-
justing, cover the seat with the fabric and put
the padded crotch strap back in place.
To switch from position B to position A repeat
the steps described above reversing the direc-
tion.

12. SUN CANOPY

The mesh sun canopy is included with some
versions of the seat.
To fit the canopy, simply attach it to the car
seat headrest using the two buttons at the
base of each arch (Fig. 31) and then thread the
headrest adjustment ring (G) through the hole
at the base of the canopy (Fig. 32).
To use the canopy, simply pull on the end and
select the most suitable position to protect
your child from the sun's rays.

13. MAINTENANCE

The cleaning and maintenance of the product
must only be carried out by an adult.
How to clean the fabric cover:
The car seat's fabric cover can be removed and
cleaned by hand or in a washing machine at
30°C. Follow the cleaning instructions provid-
ed on the label.
30° C
30° C
Never use abrasive detergents or solvents.
Do not dry the fabric cover within a dryer, let it
dry without squeezing it.
The fabric cover must only be replaced with
another cover approved by the manufacturer,
since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child
car seat, never use it without its fabric cover.
22
Machine washable at 30°C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean