Vanair AIR N ARC RELIANT 250 Series Operations Manual & Parts List page 114

SECTION 6: MAINTENANCE
A
G
1
G
KEY DESCRIPTION
A ENGINE OIL DIPSTICK HANDLE
B ENGINE OIL FILL PORT
C
ENGINE OIL FILTER
D THREADED CENTER HOLE
I
Order Replacement Engine Oil Filter No. EN38480
PAGE - 92
2
KEY
E
F
G
I
Figure 6-21: Engine Oil Maintenance
090019-OP_r0
®
AIR N ARC 200 SERIES ALL-IN-ONE POWER SYSTEM
SCHEDULE TABLE . Check the engine oil level when the
engine is off, and the oil allowed to settle.
TOOLS NEEDED
Clean Cloth
Funnel (to add oil if
necessary)
I
Engine may need additional amount of oil if low. Consult
Engine Operator's Manual for oil grade used, amount
needed, and oil change intervals. Consult Section 6.5.9.3,
Replacing the Engine Oil , to change the engine system oil.
1. Locate the engine dipstick handle [ A ] and
remove.
2. Wipe off the excess oil on the dipstick blade,
and replace the dipstick back into the engine
tube in order to get a clear level reading.
3. Remove the stick again, and observe where
the oil level shows at the gauge-end of the
stick [ G ]. Acceptable level should be within
B
C
F
DESCRIPTION
RUBBER GASKET
ENGINE OIL DRAIN PLUG
Acceptable range for engine oil level between:
G (FULL), and G (LOW) - DO NOT OVERFILL
1 2
®
REPLACEMENT
PART(S)
I
Engine Oil (if
necessary)
D
E