Compressor Belt Link Disengagement - Vanair AIR N ARC RELIANT 250 Series Operations Manual & Parts List

SECTION 6: MAINTENANCE
B
KEY
A COMPRESSOR PULLEY
B COMPRESSOR PULLEY DIRECT OF
ROTATION ARROW
C BELT PLACEMENT - Tabs face inside,
toward pulleys
Figure 6-12: Compressor Drive V-Belt - Determining Sizing and/or Link Removal
WARNING
Relieve pressure from the compressor
system before performing maintenance
on any components.
WARNING
Before performing maintenance or repair
operations on the machine, ensure that
all power has been removed and locked
out to prevent accidental start-up.
PAGE - 82
A
C
DESCRIPTION
6.5.7.5 COMPRESSOR BELT LINK
090019-OP_r0
®
AIR N ARC 200 SERIES ALL-IN-ONE POWER SYSTEM
D
F
KEY
D OUTER SIDE OF BELT TRACK - Arrows printed
on links point in the same direction as compres-
sor pulley direction of rotation arrow [B]
E ENGINE PULLEY
F OVERLAP: Align last two tabs with two holes
DISENGAGEMENT
TOOLS NEEDED
Optional Long-Nosed Pliers
Refer to Figure 6-13, and the following procedure:
1. Hold belt tab-side up with one hand; bend
back as far as possible to expose tab [B
2. With the tab now turned parallel to the slot,
push down on the tab [C] while pulling up on
the link's end [D].
3. Rotate the belt end with tab [B
tab is turned parallel to the slot.
E
DESCRIPTION
REPLACEMENT
PART(S)
Compressor
Drive Belt No.
DR270814 (2)
1
] so that the
2
®
].