Table of Contents
Advertisement
About the FaxPress Enterprise Redundant Server Setup
Each section in this chapter provides important FaxPress Enterprise Redundant setup information.
Rack Mounting or Shelf Mounting
The FaxPress Enterprise Redundant fax servers can either be rack-mounted or stationed on a shelf or desktop.
FaxPress Enterprise Redundant products are rack-mountable by attaching the two provided mounting
brackets. To mount a FaxPress Enterprise Redundant unit on a 19" rack, use the four specific screws provided
by the rack vendor. These special screws are not provided by Castelle.
By attaching the four provided rubber feet to the bottom of the chassis, the FaxPress Enterprise Redundant
unit can be stationed on a desktop or shelf. For units stationed on a desktop, the two rack mounting brackets
on both sides of the chassis may be removed.
Setup Requirements
Setting up the FaxPress Enterprise Redundant will require:
•
T1 line type and configuration parameter information in case the FaxPress Enterprise Redundant's
default fax board settings require modifying.
•
DNIS string information.
•
PBX programming, in some cases.
•
An eight-conductor RJ-45 data cable provided by the telco/line carrier.
•
A trained PBX technician present, if the FaxPress Enterprise Redundant will be connected to a PBX.
•
A CSU, CSU/DSU, or PBX (required only for units interfacing to a T1.
T1, E1 ISDN PRI or ISDN BRI Support
Note:
Dialogic has replaced Eicon as the fax boards used in the Enterprise Redundant. However, Eicon
may still be used in some of the menus, although the names are interchangeable.
The FaxPress Enterprise Redundant comes pre-configured to support one of three basic digital line types: T1,
E1 ISDN PRI or ISDN BRI. Depending on your digital line protocol and range of line extensions, some
additional fax board configuration may be required.
To determine the additional fax board configuration required for your FaxPress Enterprise, see:
•
FaxPress Enterprise Redundant T1 Line Types and Signaling on page 19
Enterprise Redundant for T1 CAS or T1 ISDN PRI.
•
FaxPress Enterprise Redundant E1 and E1 ISDN PRI (Primary Rate Interface) on page 23
configure the FaxPress Enterprise Redundant for an E1 ISDN PRI line.
•
FaxPress Enterprise Redundant ISDN and ISDN BRI (Basic Rate Interface) on page 26
the FaxPress Enterprise Redundant for ISDN BRI.
About the FaxPress Enterprise Redundant Server Setup
to configure the FaxPress
to
to configure
9
Advertisement
Table of Contents
