Configuring Printing Properties
Use the Printer, Layout, and Format tabs to configure printing properties.
To configure printing properties
1
Click the Printer tab.
2
Configure the settings described below.
• Some Label Printer models do not support variable margin settings.
• The actual amount of tape that is fed with each margin setting depends on the
Label Printer model you are using, as shown in the table below.
Margins
Model
KL-E20/KL-P1000
EL-5000W
(EZ-LABEL
PRINTER Tape)
EL-700
CW-L300
• All values in the above tables are approximate.
• Normally, you should leave the Print Density set to 3. Change this setting only
when printed characters are broken or too dark.
• With the KL-E20/KL-P1000 Label Printer, margins (small) are inserted only during
continuous printing, without tape cutting. If you want to have margins inserted,
configure the FA-B30 Software as described below.
• Print without tape cutting.
On the Display tab, clear the Stop between prints for tape cut. check box.
• Do not use a fixed tape length.
On the Layout tab, clear the Fix Tape Length check box.
Large
Approx. 16 mm
Approx. 18.8 mm
Approx. 19.3 mm
Approx. 21.5 mm
44
Medium
–
Approx. 10 mm
Approx. 10 mm
Approx. 10 mm
Small
Approx. 3 mm
Approx. 3 mm
Approx. 3 mm
Approx. 3 mm