Brother ULT-2002D Operation Manual page 3

FOR USERS IN THE UK, EIRE, MALTA
If this machine is fitted with a three-pin non-rewireable BS plug then please read the following.
IMPORTANT
If the available socket outlet is not suitable for the plug supplied with this equipment, it should be
cut off and an appropriate three-pin plug fitted. With alternative plugs an approved fuse must be
fitted in the plug.
NOTE
The plug served from the main lead must be destroyed as a plug with bared flexible cords is
hazardous if engaged in a live socket outlet. In the event of replacing the plug fuse, use a fuse
approved by ASTA to BS 1362, i.e. carrying the
Always replace the fuse cover, never use plugs with the fuse cover omitted.
WARNING
DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE
LETTER 'E', BY THE EARTH SYMBOL
The wires in this main lead are coloured in accordance with the following code:
Blue Neutral
Brown Live
As the colours of the wiring in the main lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured blue must be connected to the terminal which is marked with the letter
'N' or coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is marked with the
letter 'L' or coloured red or brown.
A-2
AND CYPRUS ONLY
OR COLOURED GREEN OR YELLOW.
Introduction
mark, rating as marked on plug.