Brother ULT-2002D Operation Manual page 143

1
4
1
2
1
6
2
3
4
3-70
6. Close the zipper, turn the fabric over, and sew a bast-
ing stitch.
1 Front of the skirt (wrong side of fabric)
2 Basting stitches
3 Front of the skirt (right side of fabric)
4 Back of the skirt (right side of fabric)
2
3
7. Remove the presser foot, and reattach it so that the left
3 side of the pin is attached to the presser foot holder.
* When sewing the left side of the zipper, the needle should
drop on the right side of the presser foot. When sewing
the right side of the zipper, the needle should drop on
the left side of the presser foot.
1 Right
2 Left
3 Needle drop position
8. Set the fabric so that the left edge of the presser foot
touches the edge of the zipper teeth. Sew reverse
stitches at the top of the zipper, then continue sewing.
Stop sewing about 50 mm (2 inch) from the edge of
the fabric, leave the needle in the fabric, and remove
the basting stitches. Open the zipper and sew the rest
of the seam.
1 Basting stitches
2 7 to 10 mm (1/4 inch to 3/8 inch)
3 Reverse stitches
4 50 mm (2 inch)
Sewing Utility Stitches
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —