Brother ULT-2002D Operation Manual page 100

5
3
1
2
2
A
1
8. Place the fabric as shown left figure B.
- Right side of cut: on top of the guide plate
5
- Left side of cut: underneath the presser foot
1 Guide plate (lower knife)
2 Presser foot
9. Thread the needle, then pull out a long section of the
upper thread, pass it below the presser foot and pull it
B
out in the fabric feed direction (see left figure B).
2 Presser foot
3 Upper thread
3
10.Lower the presser foot lever.
5
CAUTION
If the width has been adjusted, turn the balance wheel
by hand to check that the needle does not touch the
side cutter. If the needle touches the side cutter, it may
cause the needle to break.
When Sewing Straight Stitches only
The seam margin should be about 5 mm (3/16 inch).
1 Seam margin
* Make sure you select a pattern for the side cutter.
* Clean the side cutter after use, to avoid having dust
and scraps of thread build up on it.
* Add a small amount of oil as required to the cutting
edge of the cutter.
Note
• The fabric will not be cut if the whole fabric is simply
spread out underneath the presser foot guide plate. Set
the fabric as explained in step 8, and then start sewing.
• Check that the needle is raised when the presser foot
lever is raised.
• One layer of 13 oz. denim can be cut.
Sewing Utility Stitches
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —
3-27