Adjustments During The Embroidery Process; The Bobbin Runs Out Of Thread - Brother ULT-2002D Operation Manual

Brother sewing machine operation manual
Hide thumbs Also See for ULT-2002D:
Table of Contents

Advertisement

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

The Bobbin Runs Out of Thread

2
When the bobbin begins to run out of thread during sew-
ing, the message shown at left will display. If the pattern is
nearly complete at this time, you can finish the pattern
safely without changing the bobbin thread. If there is a
large portion of the pattern left to finish, it is recommended
to change the bobbin thread before continuing. If the mes-
sage at left displays, follow the steps below.
1. Press the "Start/Stop" button to stop the machine.
2. Press the "Needle Position" button to raise the needle,
and raise the presser foot lever.
3. Use scissors to cut the upper thread.
4. Remove the embroidery frame.
Be careful not to apply strong force to the fabric at this
1
time. Otherwise, the fabric may loosen in the frame.
CAUTION
Be careful not to bump the embroidery unit carriage or
the presser foot when removing or attaching the em-
broidery frame. Otherwise, the pattern will not embroi-
der correctly.
5. Insert a wound bobbin into the machine, then reattach
the embroidery frame.
6. To return to the spot in the pattern where you stopped
sewing, go to page 5-36 and follow the steps from #4.
Embroidery
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —
5-35

Advertisement

Table of Contents
loading

Table of Contents