Troubleshooting - Lectrosonics DBSM Instruction Manual

Troubleshooting

Symptom:
Transmitter Battery LED off
when Power Switch "ON"
No Transmitter Modulation LEDs
when Signal Should be Present
Receiver Indicates RF But No Audio
Receiver RF Indicator Off
No Sound (Or Low Sound Level), Receiver
Indicates Proper Audio Modulation
Distorted Sound
Wind Noise or Breath "Pops'"
Hiss and Noise -- Audible Dropouts
Excessive Feedback (With Microphone)
Rio Rancho, NM
Digital Hybrid Wireless Belt-Pack Transmitters
It is important that you follow these steps in the sequence listed.
Possible Cause:
1. Batteries are inserted incorrectly.
2. Batteries are low or dead.
1. Gain control turned all the way down.
2. Batteries are inserted incorrectly. Check power LED.
3. Mic capsule is damaged or malfunctioning.
4. Mic cable damaged or miswired.
5. Instrument Cable damaged or not plugged in.
6. Musical instrument output level set too low.
1. Audio source or cable connected to transmitter is defective. Try
using an alternate source or cable.
2. Make sure the compatibility mode is the same on transmitter and
receiver.
3. Ensure musical instrument volume control is not set to minimum.
4. Check for correct encryption key type is selected.
1. Ensure that the transmitter and receiver are set to the same
frequency.
2. Transmitter not turned on, or battery is dead.
3. Receiver antenna missing or improperly positioned.
4. Operating distance is too great.
5. Transmitter may be set to the Standby Mode. See page 6.
1. Receiver output level set too low.
2. Receiver output is disconnected; cable is defective or miswired.
3. Sound system or recorder input is turned down or not enabled.
1. Transmitter gain (audio level) is too high. Check Modulation
LEDs on transmitter and receiver while distortion is being heard.
2. Receiver output level may be mismatched with the sound
system or recorder input. Adjust output level on receiver to the
correct level for the recorder, mixer or sound system.
3. RF interference. Reset both transmitter and receiver to a clear
channel. Use scanning function on receiver if available.
4. Transmitter is at the edge of the useable range for that frequency.
1. Reposition microphone, or use a larger windscreen, or both.
2. Omni-directional mics produce less wind noise and breath pops
than directional types.
1. Receiver antenna missing or obstructed.
2. Operating distance too great.
3. RF interference. Reset both transmitter and receiver to a
clear channel. Use scanning function on receiver if available.
4. Musical instrument output set too low.
5. Microphone capsule picking up RF noise. See item on page 19
entitled Microphone RF Bypassing.
1. Transmitter gain (audio level) too high. Check gain adjustment
and/or reduce receiver output level.
2. Microphone too close to speaker system.
3. Microphone is too far from user's mouth.
29