Stick Control - Beastx MICROBEAST PLUS Manual

• When you press down and hold the button at Menu Point H (Servo trims) only the servo
trims will be reset to 0. Holding the button will not cause a full factory reset here.
• For the settings of RECEIVER MENU there is no such factory reset intended. The reset
in SETUP MENU will only reset settings that are not receiver related. To change receiver
related things like receiver type, function assignment or throttle failsafe simply perform
the setup of RECEIVER MENU again.
Never fly while MICROBEAST PLUS is in SETUP MENU or any other
menu! In this condition the gyro control and the stick controls are disabled.

28.2 Stick control

In SETUP MENU we use the sticks of your transmitter to change settings and interact
with the menu. Most often the rudder stick is used to change or adjust a value, i. e.
choose the mounting direction of the device or trim a servo center position. And on the
other hand the aileron stick (roll) is used to switch between menu items, i.e. cycle through
the servos when doing the trimming. There can be exceptions, so sometimes the sticks
simply do what they are supposed to do (i.e. pitch moves the pitch when doing the pitch
adjustment), but notice that in general the menu control with rudder plus aileron is always
the same. If not it will be mentioned in the instructions.
Stick control
69