Adjustment On The Device - Beastx MICROBEAST PLUS Manual

87 Adjustment on the device

Move the throttle stick to full throttle position. The Status-LED must light up in blue
color. This means that a new valid throttle position has been detected. If the Status-LED
lights up in red the distance between the lowest throttle position and the full throttle
position is too small. Since this will have a negative effect on the control behavior of
the system, this throttle position can not be used. In this case check the setting of
the transmitter and the programming of the speed controller or readjust throttle servo,
carburetor position and throttle linkage rod. If necessary, set the lowest throttle position
1
at menu point B again.
Similar to menu point B
you do not move the throttle stick, the currently stored position will not be changed. So
you can skip menu point C by a brief push of the button without changing the throttle
position when performing subsequent adjustments in Setup menu or Governor setup
menu. Conversely this means that you need to move the throttle stick at menu point
C at least once to change the current full throttle position!
1 https://wiki.beastx.com/./index.php/Manuals:MB_Plus:Governormenu_B/en
2 https://wiki.beastx.com/./index.php/Manuals:MB_Plus:Governormenu_B/en
2
the Status-LED is off when entering menu point C. As long as
193