Adjustment At The Device - Beastx MICROBEAST PLUS Manual

104 Adjustment at the device

When MICROBEAST PLUS is ready for operation, hold down the button until the Menu
LED next to point A flashes quickly, then release the button immediately. The flashing
menu LED A shows that you've entered menu point A of PARAMETER MENU. To
skip to the setting you like to adjust, repeatedly press the button until the corresponding
Menu LED flashes. The current setting of this menu point is shown by color and state of
the Status LED. Tapping the rudder stick left/right you can decrease/increase the value.
If you don't like to use one of the presets, you can edit each setting with the StudioX
software/StudioXm app to your likings. In this case when your custom setting does not
match the presets the Status LED will stay 'off. You can still choose one of the presets by
tapping the rudder stick, but this will erase your custom setting.
When using the bank switching feature (only with PROEDITION firmware) you can
only change the settings for bank 1 using the LED menu of MICROBEAST PLUS. The
parameters for banks 2 and 3 must be set in the StudioX software/StudioXm app. When
disabling bank switching the settings will not change as bank 1 is used by default!
235