Adjustment At The Device - Beastx MICROBEAST PLUS Manual

101 Adjustment at the device

The control style is set at PARAMETER MENU point B at the device (to enter this menu
point briefly push and hold the button from operation mode, so Menu LED A flashes, then
again brifly push the button so Menu LED B flashes). The choice is done by moving the
rudder stick in one direction until the LED indicates the desired color and state. To find
your individual preference increase the option step by step.
Status-LED
purple
red flashing
red
blue flashing
blue
If you are not satisfied with the presets, you may adjust the control behavior by using
your remote control. To do so set the control behavior to "transmitter" (Status-LED
"blue"). Then the maximum rotation rates for aileron, elevator and rudder can be
adjusted by increasing or decreasing the servo travel for the corresponding function in
your transmitter or by using the "Dual rate" function. 100% stick throw (servo throw)
in the transmitter are equivalent to a rotation rate of apprx. 400deg/s on cyclics and
600deg/s on rudder in this mode. (So for example when you would set the rudder out-
put to 50% in the transmitter, the heli rotates at 300deg/s with full rudder stick deflection.)
To adjust the sensitivity around mid stick position you can use the "Expo" function of your
transmitter. Please refer to the manual of your transmitter.
Notes:
• When you've changed the preset control style using the StudioX or StudioXm App the
Status LED will be off. You can change back to a preset by tapping the rudder stick as
described, but this will remove your custom setting!
• When using the bank switch feature (PROEDITION firmware only) you can only adjust
the settings for flight mode/bank 1 using the LED menu on the device. The settings
for banks 2 and 3 must be changed in StudioX/StudioXm. When deactivating the bank
switching, still you will see the settings of bank 1 here, as bank 1 is the default bank
Control style
normal
sport
pro
extreme
transmitter
229