Setting Bank Switching With Studiox - Beastx MICROBEAST PLUS Manual

119 Setting Bank Switching with
StudioX
When StudioXm has connected to your MICROBEAST PLUS in the device overview main
screen click the "Parameter" button. Then click the "Next" button repeatedly until you
reach the screen "Bank 1 - Gains" or directly go to this options screen using the box on
top. Here you can aktivate Bank Switching clicking the specific button below the gain
adjustments. When Bank switching is activated the following screens are accessible and
can be used to change parameters of each of the Banks 2 & 3 besides the Paramters of
Bank 1 in the beginning.
Please note that the first screen "Quick trim" has global effect, meaning that the values set
here are used in all of the Banks. Separate trimming for each bank is not provided.
When you've set a separate control channel for the AttitudeControl function in "Control
setup" the gain adjustment for AttitudeControl in the App will have no effect. Only you
can use Bank Switching then to change between different rescue modes in flight. On the
other hand when you did not assign a separate channel for the AttitudeControl, you can
set the AttitudeControl gain for each bank/flight mode and use the Banks/flight modes to
activate/deactivate the rescue in flight. Note that AttitudeControl will enable when the
gain is higher than 12! Check the status display on the device overview main screen or the
display on the device to see if AttitudeControl is active and what gain is set!
287