Throttle Failsafe - Beastx MICROBEAST PLUS Manual

The first 6 functions must be assigned as they are necessary for the basic flight control.
The other functions are optional to assign and can be skipped. If special features like
AttitudeControl or Headspeed Governor are not installed on your device, the specific menu
points for assignment will not be shown at all.
• The assignment for Aux [CH6] Output can be skipped by pressing the "Skip" button
without teaching a channel for this function in case it is not used.
• Likewise, the assignment of the channel for internal governor can be skipped in case it is
not needed or if you don't want to control the governor with a separate channel, e. g. if
your transmitter does not provide enough free channels. By skipping the assignment the
internal governor function will use a different operating mode that allows to control it by
the throttle channel if you like. When used in an electric model the internal governor is
controlled by the throttle channel in general. In this case the assignment can be skipped
anyway, as it will have no effect.
• Finally, you can assign the channel that is used to engage the AttitudeControl/rescue
stabilization (only available you've installed the PROEDITION Upgrade on your device).
Again this can be skipped if not needed or if you don't want to use a separate channel
or in case you have no more free channels left). AttitudeControl can still be used then.
In this case the channel for the tail gyro gain is used to engage AttitudeControl or can
be enabled separately using the Bank Switch feature. Please see the section about using
AttitudeControl for further details.
•
If the Status-LED lights in red color this means either there is no valid remote control
signal available or that you did try to assign two or more channels to a function. So
check if the receiver is connected and powered properly and that you're only moving one
channel at a time when trying to do the manual function assignment.

26.3 Throttle failsafe

After you've set the control functions you will be asked to program the failsafe position
for the throttle channel. In case the single-line signal is interrupted during operation, the
throttle servo/speed controller connected to the [CH5] Output is automatically moved to
this position. This particularly is the case:
• if using a single-line receiver that turns of the single-line signal in case of signal loss be-
tween receiver and transmitter (e.g. Spektrum® satellite receiver or Graupner® receiver
in „SUMDOF" mode)
• if the connection between MICROBEAST PLUS and receiver gets disconnected
Throttle failsafe
63