When The Update Fails - Beastx MICROBEAST PLUS Manual

139 When the update fails

When the update does finish completely usually the device will be stuck in recovery mode
as the main application is erased now. This is no problem at all! Just try again. If the
update fails again and again at some point, completely close the app and power off your
device. Power on again, start the app and try again. If that all does not work you please
try another computer or smartphone.
Especially when using the bluetooth connection do as mentioned above: stay away
from radio devices that may interfere with the bluetooth connection and try to stay
as close to the BLE2SYS as possible. When using a computer in combination with
USB2SYS make sure there are no processes running in background that may interrupt
USB communication. Especially when using a virtual machine for running the StudioX
app it may happen that the USB connection is slow and not performing properly.
So do not use a virtual machine for running the app. Also make sure drivers are
installed and configured properly. In very rare cases it can be that the wire or plugs
from USB2SYS to your device may be damaged or have a loose connection, so try a
different connection cable. Finally make sure your power supply/battery is fully charged
and holding voltage and disconnect all servos for the update procedure as mentioned above.
331