Adjustment On The Device - Beastx MICROBEAST PLUS Manual

41 Adjustment on the device

To select the desired servo frequency, move the rudder stick repeatedly in one direction
until the Status-LED lights in the correct color. Please note that depending on the rudder
servo center pulse width chosen at Menu Point C, you may not be able to select a frequency
higher than 333Hz!
Status-LED
purple
red flashing
red
blue flashing
blue
Note: When you set a different pulse width with StudioXm the Status LED will be off.
You can change back to a preset setting by tapping the rudder stick as described, but this
will remove your custom setting!
Rudder servo frequency
50 Hz
165 Hz
270 Hz
333 Hz
560 Hz
95