Advertisement
Things to check before using your brush cutter
Before beginning work, look around carefully to get a feel
•
for the shape of the land or grass to be trimmed and
whether or not there are any obstacle which might get in
the way white working, and remove any obstacles, which
can be cleared away.
The area within a perimeter of 15 m of the person using
•
the brush cutter should be considered a hazardous area
into which no one should enter while the brush cutter is in
use, and when necessary yellow warning rope, warning
signs should be placed around the work area. When work
is to be performed simultaneously by two or more persons
always check the presence and locations of others so as
to maintain a distance each person.
Make sure that there are no loose screws or bolts. fuel
•
leaks, ruptures, dents, or any other problems, which might
interfere with safe operation. Be especially careful to check
that there is nothing wrong with the blades or with the
joints by which the blades are attached to the brush cutter.
Never use blades that are bent, warped, cracked, broken
•
or damaged in any way.
Keep the blade always sharp.
•
Filling the cutting edges, keep the end corner sharp and
•
round the root of the edge.
Check the boll to fasten the blade and be sure the blade
•
turns smoothly without abnormal noise.
Notes on starting the engine
1. Take a careful look around to make sure that no obstacles exist within a perimeter of 15 m or
less around brush cutter.
2. Place the body of the brush cutter onto the ground in a flat clear area and hold it firmly in place
so as to ensure that neither the blades nor the throttle come into contact with any obstacles
when the engine starts up.
3. Place the throttle into the idling position when starting the engine.
4. After starting up the engine, if the blades continue to rotate even after the throttle has been
moved fully back, turn off the engine and check the throttle wire and other parts.
Kickback safety precautions
A dangerous reaction may occur when the spinning blade contacts a solid object in the critical area.
This is called kickback. As a result, the operator can lose control of the unit, which can cause serious
or fatal injury. Avoid kickback, observe the safely precautions below strictly:
1. Before beginning work, clear your working area.
2. When using your brush cutter do not grip other parts except the handles.
3. When using your brush cutter never take your eyes off, if you need to place the throttle into
the idling position.
4. When using your brush cutter do not let the unit get close to your feet nor raise the unit above
your waist.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61495, 61496
Page 7
02 2021-2
Advertisement
