Advertisement
Idle adjustment screw (F17)
Maintenance before storing
1. Brushing off dirt form the machine check damage or stack of each part if you find out abnor -
malities, repair them for the next use.
2. Extract fuel from the tank and loose the drain screw of the float cabin to extract fuel, turn on
the engine and leave it running until it stops naturally.
3. Remove the spark plug and put in 1–2 cc of 2-cycle oil in the engine. Draw the starter rope 2–
3 times, set the plug back and stop it at the contraction position.
4. Apply anti-rust oil to the metal parts such as the throttle wire put the security cover on the
blade and keep the machine indoor avoiding dampness.
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
a) This is the screw to adjust the engine rotation when
the throttle lever is set to the lowest speed position.
b) If you turn right (clockwise) the rotation increases and
left (counter-clockwise) decreases.
c) In case the blade continues to rotate or engine stops
when you return the throttle lever completely to the ori-
ginal position, make a readjustment.
№ Name
1
Idle adjustment screw
2
High
Item 61495, 61496
№ Name
3
Low
Page 17
02 2021-2
Advertisement
