Advertisement
Adjusting the throttle cable (F5)
Installing the metal blade (F6)
Installing the nylon cutter (option) (F7)
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
a) After releasing the throttle lever pull the throttle wire.
The normal play is 1 or 2 mm when measured at the
carburettor side end.
2. If the play is too short or too long, take off the air
cleaner cover, loosen the lock nut and adjust the play.
№ Name
1
Adjust nut
a) Set the inner holder to the gear shaft and fix with the
attached L-shaped bar.
b) Put the blade on the inner holder with letters to the
gear case and match correctly the hole of the blade to
the projection of the inner holder.
c) Set the outer holder to the gear shaft with the hol-
lowed face to the blade.
d) Put the attached bolt cover on the outer holder and
secure it with the bolt (left screw) together with the
spring washer and the washer.
№ Name
1
Nut
2
Spring washer
3
Washer
4
Outer holder
5
Blade
a) Set correctly the inner and the outer holder to the
gear shaft.
b) Screws the attached bold (M8, left) into the gear
shaft and secure it with the spanner.
c) Screw the nylon cutter into the bolt by fixing the inner
holder with the L-shaped bar and tighten it manually.
d) Keep bolts and washers to install the blade carefully.
№ Name
1
Gear case
2
Bolt
Item 61495, 61496
№ Name
2
Lock nut
№ Name
6
Gear shaft
7
Bar
8
Inner holder
9
Gear case
№ Name
3
Nylon cutter
4
Nylon cord
Page 10
02 2021-2
Advertisement
