CAPITOL HY- 6900 Service Manual page 34

7. Press ball bearing into forward clutch
flange. Press bevel gear into ball bearing.
8. Likewise press the other ball bearing into
reverse clutch flange (fig.26). Then press
bevel gear into ball bearing. Check that ball
bearings on both flanges are well seated.
9. Arrange the driving friction discs (external
tooth) with the steel driven discs (internal
tooth) against the forward and reverse clutch
flanges. Refer to the appropriate illustration
in section 7. parts information.
10. Position reverse clutch flange and
reverse clutch discs on reverse side of gear
carrier (flange on commutator bushing is on
reverse side). Position forward clutch flange
with forward clutch discs and fasten both
flanges to gear carrier. Tighten capscrews to
25 pounds-foot torque.
11. Check for free movement of gears in
clutch assembly.
Clutch assembly is now ready for installation
on stub shaft. See page 7 for clutch
mounting instructions.
33