Table of Contents
Advertisement
3.3 INSTALLATION OF
TRANSMISSION
1.
Apply a small amount of grease to oil
dam adapter and locate gasket.
2.
Remove side inspection covers to
facilitate installation.
3.
Remove oil pump and oil pump drive
shaft.
4.
Using an adequate hoist and hoist
guide (special tool no. 1-90021-0000) lift
transmission into position behind
engine. Ease unit forward over clutch
assembly gently twisting transmission
housing so that discs enter reverse
drum properly without damaging teeth.
A screwdriver may be used through the
side inspection hole to align disc teeth
with the reverse drum.
5.
Secure transmission housing to oil dam
adapter with capscrews and
lockwashers.
6.
Check clutch end float: insert
screwdriver through side inspection hole
and pry clutch fore and aft. See fig. 20,
page 22. End float should be 1/16" to
3/32".
7.
Turn output coupling over for several
revolutions making sure unit is free to
turn.
8.
Replace oil pump drive shaft, gasket
and oil pump. Secure pump with
capscrews and lockwashers.
9.
Replace oil pump drive shaft, gasket
and oil pump. Secure pump with cap
screws and lock washers.
13
Advertisement
Table of Contents
