Table of Contents
Advertisement
3.
Replacement of return springs and
retainers (If necessary): Insert return
spring retainers into return springs and
secure in gear carrier using capscrews.
Tighten capscrews tentatively until top
of spring retainer protrudes the specified
distance from the face of the bevel gear
carrier hub as shown in figure 24.
4.
Without installing quad rings, place
cylinders on bevel gear carrier by hand.
(See fig.25) above. There must be a
uniform gap between cylinders of .015
to .025". Check with a feeler gauge. If
necessary, readjust return spring height
and install locknuts.
5.
Apply lube in seal ring grooves in bevel
gear carrier and slip on four new quad
rings avoiding twists in the rings.
6.
To Install cylinders:
A.
Apply a light coat of lubricant
on inner walls of each clutch
cylinder as well as quad rings.
B.
With forward side of gear
carrier up, press cylinder on by
hand (See fig. 25).
CAUTION:
To prevent twisting or damaging of
seal rings, take care to slip cylinders
on evenly and straight down.
C. Turn bevel gear carrier over (reverse side up)
and press remaining cylinder on, checking to see
that cap screw holes in both cylinders are aligned
properly.
D. Insert capscrews and locknuts and tighten to
16 pounds-foot torque.
32
Advertisement
Table of Contents
