Device Installation; 3�1�- Prior Recommendations - Circutor CVM-C4 Instruction Manual

3 .- DEVICE INSTALLATION

3�1�- PRIOR RECOMMENDATIONS
The CVM-C4 device must be installed by authorised and qualified staff.
The power supply plug must be disconnected and measurement systems switched off before handling,
altering the connections or replacing the device. It is dangerous to handle the device while it is pow-
ered.
It is critical to keep wires in perfect condition to avoid accidents, personal injury or damage to instal-
lations.
Limit the operation of the device to measuring the specified current or voltage values.
The manufacturer of the device is not responsible for any damage resulting from failure by the user
or installer to heed the warnings and/or recommendations set out in this manual, nor for damage
resulting from the use of non-original products or accessories or those made by other manufacturers.
Do not use the device to take measurements if you detect an anomaly or malfunction.
8
In order to use the device safely, it is critical that individuals who handle it follow the
safety measures set out in the standards of the country where it is being used, using
the personal protective equipment necessary (rubber gloves, face protection and ap-
proved flame-resistant clothing) to prevent injuries due to electric shock or electric arc
as a consequence of exposure to current-carrying conductors and paying attention to
the various warnings indicated in this instruction manual.
Disconnect the device from the mains and from the power supply (both the device and
its measuring system) before performing any maintenance work, repairs or handling
any of the connections of the device.
Contact the after-sales service if you detect that the device is not working properly.
CVM-C4
Instruction Manual