Table of Contents
Advertisement
SETTINGS
? A
?
003
11. 494 GHZ
$
H – A
7.02 MHz 7.20 MHz
~
PANDA BW 1
( (
–
{
1
/ /
– – –
+
=
/
OK
The sub-menu »3:
/ /
1
{
1
25
{
2
11
–
) )
ENGLISH
/
OK
_______________________________________________________________________________
Note:
This applies both when reception unit
that requires the decoder is active.
It is only possible to change the decoder setting for channels of reception unit
the reception unit
B
(INPUT B) is not using the decoder.
If reception unit
B
(INPUT B) is using the decoder the decoder setting field for channels of recep-
tion unit
(INPUT A) will appear as "– – –" and is not accessible.
A
During a timer event on reception unit
the decoder, the main menu only allows access to the timer sub-menu
Video polarity
+
You can set a positive "
" or negative "
+
The "
" setting is pre-programmed. For some decoders, you may need the "
« ( Baisc set-up)
/ /
1
Press the » « button followed by the »3« button to display the Basic set-up sub-menu.
Key to the symbols:
/
Decoder mode selection 1-4 (e.g. 1 = Normal, CCVS)
1
{
Contrast level 1 (preset value = 25)
1
25
{
Contrast level 2 (preset value = 11)
2
11
) )
–
Receiver lock "yes"
Language of the
ENGLISH
Exit menu without saving
Save then exit menu
OK
B
(INPUT B) is set to a decoder channel or a timer event
B
(INPUT B) where the channel being recorded is using
–
" video polarity using the »
»1:
« timer sub-menu
(INPUT A) when
A
»1
«.
:
; :
;
:
« button.
–
" setting.
35
Advertisement
Table of Contents
