Table of Contents
Advertisement
TIMER PROGRAMMING
2
?
?
001
G
WED
WEEK 2
G
20:03
GI 22:03
–
19:28
SUN
/
OK
Choosing a channel position (
1
?
?
Select the »
001« row using the
2
Enter the desired channel position number with the buttons
;
; :
:
»
« buttons.
Entering the day and week of recording (
1
Select the »
WED« row with the
2
Select the day or DAILY (= daily recording a the same time) using the »
3
.
With
».
« you may switch from DAY to WEEK, with
DAY.
4
Select WEEK 1, 2, 3, 4 or WEEKLY (= weekly recording at the same time) using the »
buttons.
Entering the start time (
Note:
To make sure that the required programme will still be recorded in its entirety, even if there is a
change in the transmission time, when programming the timer data you should always set the
start time a bit earlier and the stop time a little later than the times mentioned in the TV guide.
G
1
Select the »
20:03« row using the
2
You may switch between hours (0 ... 23) and minutes (0 ... 59) using the
,
Press the
»,
« button to switch back from minutes (0 ... 59) to hours (0 ... 23).
3
Enter the start time using the
____________________________________________________________
?
?
)
, .
.
»,
« buttons.
.
».
« button.
»,
G
)
.
».
« button.
»1 ... 0
« buttons, or select it using the »
»1 ... 0
«, or select it using the
G
SU)
;
; :
:
« buttons.
,
« you may switch back from WEEK to
.
».
« button.
;
; :
:
« buttons.
; :
;
:
«
25
Advertisement
Table of Contents
