Table of Contents
Advertisement
) ) – – . .
/ /
1
{
1
25
{
2
11
) )
ENGLISH
/
OK
30
BLOCKING THE RECEIVER
Unblocking the receiver temporarily
1
If you switch the receiver on from standby, the following will appear on the picture screen:
») )
. . . .
2
Press the following buttons consecutively on the remote control: »
.
Each dot (
) represents a button on the remote control. After each button has been pressed,
the dot will be replaced with a short line (–).
Note:
Once the correct sequence has been entered the receiver will be unblocked. Switching the
receiver into standby mode will block it again.
While the receiver is switched on, it can be unblocked at any time using the »Basic set-up«
sub-menu.
Unblocking the receiver definitely
1
Switch the satellite receiver on. Press the » « button followed by the »
»
/ /
« sub-menu (Basic set-up).
3:
2
») )
Select the
3
Switch the receiver lock off by pressing the »
») )
–
« ( = receiver lock off).
4
Press the » OK« button to save the setting.
– The main menu appears on the picture screen again.
5
Press » « to exit the menu.
__________________________________________________________
«.
« row.
:
:
;
;
«, »
3
;
;
:
:
« or »
« button once.
. «,»,
,
«,
».
«
« button to display the
Advertisement
Table of Contents
