Pre-Programming; Explanatory Notes About The Table Of Stations - Grundig STR 7122 TWIN Manual

PRE-PROGRAMMING

Explanatory notes about the table of stations

The extra station table attached provides an overview of the pre-programmed channels on each
satellite.
In the station table, the channels of each satellite are grouped together and marked with a number
1 2
(e.g. Astra,
Example:
So that the Eutelsat 13°/Hotbird satellite can be received together with the Astra or Eutelsat 16°
satellite, their channel positions are pre-programmed several times.
When receiving from more than one satellite, the pre-programming facility supports aerial
systems with either a digital DiSEqC signal (DiSEqC 1.0), a ToneBurst switch (settings A/B) or
a 22 kHz switch (settings – 0 kHz/
The table below shows several examples of use:
Which channel position groups can be used for the reception of which satellite (using the appropriate
aerial ? How many further combinations are possible.)
Desired
satellites
Astra (TV) + Eutelsat 13° (TV) +
Astra Radio + Eutelsat 13° Radio
Eutelsat 13° (TV) + Eutelsat 16° (TV)
Eutelsat 13° (TV) + Türksat 42° (TV)
Eutelsat 13° Radio + Türksat Radio
Astra (TV) + Eutelsat 13° (TV)
Astra (TV) + Türksat 42° (TV)
*
LNC for the 11 GHz range.
**
LNC for the 11 and 12 GHz range. When using a Universal LNC, the LO frequencies must be corrected in the "LNC set-up"
sub-menu, see section "LNC oscillator frequencies", page 38.
_________________________________________________________
Eutelsat etc.).
~
22 kHz).
Channel
groups
1
+
ß?
+
2
+
2
+
ß`
+
1
+
1
+
LNC
2
+
ß`
Single*
3
Single*
7
+
ßQ
Single*
4 5
+ Universal **
7
Universal **
Switch
required
22 kHz switch
22 kHz switch
22 kHz switch
DiSEqC 1.0, ToneBurst
DiSEqC 1.0, ToneBurst
19